科创达冷热设备-精工产品专业制造!

Replacement method of yuba drying net

2020-02-27

Yuba dryer is mainly used for water vapor, curing, and drying of hardware accessories to improve performance.It is also widely used in the food industry.It is divided into a belt baking line and a mesh belt baking line. In contrast, the mesh belt can adapt to The temperature is about (200 degrees), and the temperature of the belt baking line is between (normal temperature -200 degrees). At the same time, it is also used to dry materials with certain humidity or granularity, such as iron ore, titanium ore, quartz sand, and other minerals.

When the drying net of the yuba dryer is damaged, it should be replaced in time. Below, Ke Chuangda will tell you about the replacement method of yuba drying net.

The replacement method of the drying net of the yuba dryer is: first remove the sprocket of the main drive end of the layer of drying net, the operator faces the machine, and unscrew the bolts on the end cover of the main and passive shaft ends of the layer of drying net on the left side of the machine , Pull out the main and passive shaft components, open the survey door, take out the drying chain chain out of the box, when replacing the new drying net, pay attention to the 6-8 net support rollers each distance stainless steel wire to fasten the net and the support roller , And then follow the reverse steps above to install and debug. Note that when adjusting the tension of the drying chain chain with the adjusting bases at both ends of the passive shaft, the chain should not be too tight or too loose, and the tension of the left and right chains must be the same.

In addition, all parts of the hot blast stove used with the dryer, such as the hearth, grate, chimney, inner wall, and hot air pipe joint number, should be checked for damage. If they are damaged, they should be corrected or replaced. The maintenance of the reducer, bearing and chain of the machine is the same as above. Related common sense: What are the safety tips for exploring the dryer?

In order to ensure the normal operation of the yuba dryer, it is necessary to perform daily maintenance. Check whether the indicators of the dryer are normal on time, check by the measurement department at regular intervals, test whether the motors are operating normally, and perform regular maintenance. If there is looseness in the fastening part, and if there is any abnormal sound, remove the fault in time.

Related News

Product Recommended

  • Sludge dewatering and...
  • Tunnel drying line
  • Split type dryer A se...
  • Drying room type drye...
  • Integrated dryer C se...
  • Dehumidifying dryer D...